Your CSUSM Area Locksmith

Park the vehicle where I can open the driver's door fully and reach the OBD-II port under the dash. If you're getting a spare from an existing key, have it with you. All-keys-lost means I'll need the VIN, which is on your registration or visible through the windshield. As a NASTF Vehicle Security Professional, I pull factory key codes and security PINs directly, so nothing needs to come from the dealer ahead of time. Have your license ready and you're set.

That's usually a worn contact pad, not a board failure. The rubber membrane under each button compresses thousands of times and stops making solid contact with the circuit trace. If the pad is shot, a replacement fob is cleaner than patching. Last month a Highlander owner near Discovery Elementary had a trunk release button die on a two-year-old fob. Popped the case, confirmed the carbon contact was flattened, swapped the fob, and registered the new one to the immobilizer in about 20 minutes. Hiscox insured on every vehicle I touch.

Depends what you need it to do. A valet key starts the engine and opens doors but won't pop the glove box or trunk. Cheaper, and it works fine as a spare you leave with a neighbor while you're on vacation. A full key or fob does everything including remote lock, unlock, and trunk. For a Pilot or Highlander sitting in the driveway during a trip, a valet key in a lockbox is solid peace of mind. I carry both options, and I'm Google Guaranteed, so either way the work is backed.

Both work. Hand me a key in good shape and the Condor reads the cuts directly from the blade. If it's worn, I go by VIN instead, which pulls the original factory code before years of pocket wear changed the profile. A Sienna owner off Twin Oaks Valley Road handed me a key so smooth the cuts were nearly flat. VIN code gave me the original spec, the Dolphin cut it clean first try. BBB A+ rated, and every key gets tested in the door and ignition before I leave.

Maybe. San Marcos summers push dashboards past 150 degrees inside a closed car. That heat warps plastic fob housings, kills the coin battery, and can weaken solder joints on the transponder board. The blade is fine, metal doesn't care. But the electronics might not transmit a clean signal anymore. I test the fob with a frequency reader before you commit to anything. If the chip responds, a fresh battery is all you need. If it doesn't, a replacement fob is the safer call before a long drive. BSIS licensed locksmith, LCO 6792.

For a proximity fob on a Highlander, Pilot, or Sienna, $400 to $600 at the dealer is standard. That covers the part, programming labor, and sometimes a diagnostic fee on top. The real hit is the tow if you've lost every key and the car can't drive in. As a NASTF certified locksmith, I carry the same factory code access the dealer uses, and I run $245-$325 for a smart key cut and programmed in your driveway near Barham Drive. No tow. Over 100 five-star Google reviews from families who skipped that dealer wait.