EZ Car Keyz Pierpont

I come to you. Every Pierpont call is on-site service, whether you're stuck in the lanes off Seaward Avenue or stranded at the Marina Park lot with sand in your pockets and no key. I carry cutting machines, blank key stock, and transponder programmers for most makes, so everything from diagnosis to final start test happens at your vehicle. Typical Pierpont arrival runs 12-18 minutes. I'm not dispatching from a call center across the county (I hold BSIS license LCO#6792 and work Ventura County full-time). You don't go anywhere. I show up, fix it, and you're back on the road.

When both fobs quit at once, the fobs aren't the problem. The vehicle is. A dead 12V battery or corroded terminals, and in Pierpont the salt air chews through battery connections faster than anywhere inland, can drop voltage enough to reset the body control module. The BCM loses its pairing with both transponder codes simultaneously, so neither fob registers even after you replace the car battery. A Ford F-150 owner on Pierpont Boulevard swapped his truck battery last month and neither fob would start the engine afterward. I ran a full re-registration for both fobs through the Autel IM508 (as a NASTF-certified Vehicle Security Professional, I pull the same secure PIN data the dealer uses). Twenty-five minutes and both fobs worked clean.

That blinking light is your immobilizer standing guard. Engine off, no key in range, a slow steady blink means the system is armed and working normally. Nothing wrong. The problem starts when that light blinks rapidly, stays solid, or flashes while you're turning the key. That means the immobilizer can't read the transponder chip in your key. Could be a worn chip, a dying fob battery, or a module glitch from a voltage drop. I diagnose it at the vehicle (every job is backed by Hiscox insurance from the moment I start working) and tell you exactly what's happening before any billable work begins.

No diagnostic fee. If I show up, identify the problem, and fix it, you pay for the completed service. If I get there and your vehicle needs something I can't handle on site, like a dealer-only ECU reflash on certain late-model systems, you don't pay anything. I'd rather be upfront about that than waste your time. Every diagnosis runs through actual scan tools, not guesswork (I'm Google Guaranteed, meaning Google has verified my license and insurance before I show up at your door in Pierpont). I'll have an answer within a few minutes of plugging in.

Every lockout I run uses a Lishi pick that enters through the door cylinder cylinder, the same keyway your key goes into. No air wedge bending the door frame apart. No slim jim scraping down the window channel. No pry bar pulling on trim panels. Last summer a Chevy Silverado owner near the Seaward beach lot called me after roadside assistance had already tried wedging the door and left a crease in the weatherstrip. I picked the cylinder in about 90 seconds. The pick goes in the lock, not around the door (I carry a BBB A+ rating and stand behind every job). That's the difference between a locksmith tool and a brute-force approach.

The dealer orders your key blank from a regional warehouse. That wait runs three to seven business days. Then you need a tow to their service bay, then a programming appointment, then a bill that runs 30 to 50 percent higher than mine. I carry Ford, Chevy, Toyota, and Honda blanks in stock and cut them on site in Pierpont. The entire job, blade cutting to immobilizer programming to final start test, happens in your driveway or at the curb. Over 1,000 five-star Google reviews from Ventura County customers back that up (and as a NASTF-certified locksmith, I pull the same factory security data the dealership uses). Same result, same day, less money.