2008 Land Rover Range Rover
Key Replacement - Save vs Dealer in Ventura County

2008 Land Rover Range Rover Remote Flip Key Replacement - Fast, Affordable & Professional

Got a call from a guy in the Downtown Carpinteria area with a 2008 Range Rover sitting in his driveway, one key to his name, and that key was falling apart. The flip blade was loose in the housing, wobbling at the pivot pin, and the plastic shell had a hairline crack running along the seam. He said he had been nursing it for months, holding it together when he turned the ignition.

I got there in about twenty minutes. Pulled the old key apart on his tailgate. The PCF7941 chip board inside was fine, no corrosion, no damage. The problem was just the shell and the worn pivot. I transferred the original electronics into a fresh case with a new uncut blade, then cut the blade to match using his door lock for decoding.

Here is the part people forget. When you move the internals to a new shell, there is no reprogramming needed. The car already knows that chip. So after the cut, I tested the blade in the ignition, cycled the key through all positions, checked that the immobilizer accepted it on start, and then ran the lock, unlock, and trunk buttons on the remote. Everything worked clean.

He kept turning the new key over in his hand like he was inspecting it. Then he just said, "I should have done this six months ago." Probably right. A cracked shell gets worse fast, and if that blade snaps off inside the ignition barrel, you are looking at a much bigger job.

BSIS Licensed

LCO#6792

CA Bureau of Security & Investigative Services

NASTF Certified

National Automotive Service Task Force

Fully Insured

Liability & vehicle damage coverage

Google Guaranteed

Verified & backed by Google